H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 44)

29
To do… Use the command… Remarks
Enter console user interface
view user-interface console first-number
[ last-number ]
—
Specify the scheme
authentication mode
authentication-mode scheme
Required
By default, users that log in through
the console port are not
authenticated.
Return to system view quit —
Configure
the
authentica
tion mode
Enter the ISP
domain view
domain domain-name
Optional
By default, the AAA scheme is local.
If you specify the local AAA scheme,
you need to perform local user
configuration.
Apply the
specified AAA
scheme to the
domain
authentication default { local |
none }
Exit to system view quit
Create a local user and enter
local user view
local-user user-name Required
Set the authentication password
for the local user password { cipher | simple }
password
Required
Specifies the command level of
the local user
authorization-attribute level level
Optional
By default, the command level is 0.
Specify the service type for the
local user
service-type terminal
Required
By default, no service type is
specified.
Configure common settings for
console login
—
Optional
See “
Configuring common settings
for console login (optional) .”
When users adopt the scheme mode to log in to the SecBlade card, the level of the commands that the
users can access depends on the user privilege level defined in the AAA scheme.
When the AAA scheme is local, the user privilege level is defined by the authorization-attribute level
level command.
After the configuration, when you log in to the SecBlade card through the console port, you are
prompted to enter a login username and password. A prompt such as <H3C> appears after you input
the password and username and press Enter, as shown in Figure 11 .