Nms login, Nms login overview, Configuring nms login – H3C Technologies H3C SecBlade NetStream Cards User Manual
Page 61
46
NMS login
This chapter includes these sections:
•
•
•
NMS login overview
A Network Management Station (NMS) runs the SNMP client software. It offers a user-friendly interface
to facilitate network management. An agent is a program that resides in the SecBlade card. It receives
and handles requests from the NMS. An NMS is a manager in an SNMP enabled network, whereas
agents are managed by the NMS. The NMS and agents exchange information through the SNMP
protocol. At present, the SecBlade card supports multiple NMS programs, such as iMC.
By default, you cannot log in to the SecBlade card through NMS. To enable NMS login, log in to the
SecBlade card via the console port and make the configurations described in the following table.
The following table shows the configuration requirements of NMS login.
Object Requirements
SecBlade card
Configure the IP address of the management Ethernet interface
Make sure the SecBlade card and the NMS can reach each other
Configure SNMP settings
NMS
Configure the NMS. For more information, see the user guide of your NMS
Configuring NMS login
Connect the Ethernet port of the PC to an Ethernet port of SecBlade, as shown in
. Make sure the
PC and SecBlade can reach each other.
Figure 17 Network diagram for configuring NMS login
Follow these steps to configure SNMPv3 settings:
SecBlade
Host
GE0/2
IP network
Device