H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 305)

290
Configuration procedure
NOTE:
For the configurations for the NMS and SecBlade, see “ SNMPv1/SNMPv2c configuration example ” and
“ SNMPv3 configuration example .”
# Enable logging display on the terminal. (This function is enabled by default so that you can omit this
configuration).
<SecBlade> terminal monitor
<SecBlade> terminal logging
# Enable the information center to output the system information with the severity level equal to or higher
than informational to the console port.
<SecBlade> system-view
[SecBlade] info-center source snmp channel console log level informational
# Enable SNMP logging on the SecBlade to log the GET and SET operations of the NMS.
[SecBlade] snmp-agent log get-operation
[SecBlade] snmp-agent log set-operation
• The following log information is displayed on the terminal when the NMS performs the Get
operation to the SecBlade.
%Jan 1 02:49:40:566 2006 SecBlade SNMP/6/GET:
seqNO = <10> srcIP = <1.1.1.2> op = <get> node = <SecBlade (1.3.6.1.2.1.1.5.0)> value=<>
• The following log information is displayed on the terminal when the NMS performs the Set
operation to the SecBlade.
%Jan 1 02:59:42:576 2006 SecBladeSNMP/6/SET:
seqNO = <11> srcIP = <1.1.1.2> op = <set> errorIndex = <0> errorStatus =<noError> node
= <SecBlade(1.3.6.1.2.1.1.5.0)> value = <SecBlade>
Table 23 Description on the output field of SNMP log
Field Description
Jan 1 02:49:40:566 2006 The time when the SNMP log is generated
seqNO
Serial number of the SNMP log (The system numbers the recorded SNMP logs
automatically; the serial number starts from 0)
srcIP IP address of the NMS
op SNMP operation type (GET or SET)
node Node name of the SNMP operations and OID of the instance
erroIndex Error index, with 0 meaning no error
errorstatus Error status, with noError meaning no error
value
Value set when the SET operation is performed (This field is null, meaning the
value obtained with the GET operation is not logged.)
When the value is a string of characters and the string contains characters not
in the range of ASCII 0 to 127 or invisible characters, the string is displayed in
hexadecimal. For example, value = <81-43>[hex]