3 ethernet connection, 4 ieee 1394 connection, Ethernet connection – Grass Valley DMC 1000 v.12.4 User Manual
Page 112: Ieee 1394 connection
112
DMC 1000 Digital Media Camcorder User’s Guide (v4.0)
Chapter 10 - Communications
10.3 Ethernet connection
The camcorder uses TCP/IP as its communication protocol. Change the Ethernet settings in
the SYSTEM
>
HARDWARE
>
PORTS
>
NETWORK
menu. Below are the default network settings
used by the camcorder:
10.4 IEEE 1394 connection
Connect external IEEE 1394 devices to this connector. The external device can used to ingest
streaming video data from the camcorder. Select the playback method in the
SYSTEM
>
HARDWARE
>
PORTS
>
IEEE
1394
menu:
☞
Note
☞
Note
Playback on the IEEE 1394 port is available for SD video standards using the DV25 video
codec.
Item
Default setting
IP address
192.168.1.10
Subnet mask
255.255.255.0
Gateway address
0.0.0.0
IEEE 1394 setting
Video playback
Off
Playback on IEEE 1394 port is disabled (default)
Exclusive
Playback on IEEE 1394 port only (no video is shown on the side panel display)
Both
Playback on IEEE 1394 port with simultaneous video monitoring on the side panel
display (lower video frame rate may be possible)