Grass Valley DMC 1000 v.12.4 - Manual (Page 27)

DMC 1000 Digital Media Camcorder User’s Guide (v4.0) 27
Chapter 2 - Attaching parts
2.2.2 Positioning the viewfinder
Lateral position
1. Loosen the locking ring . As seen from camcorder rear, turning the locking ring
counterclockwise loosens it.
2. Slide the viewfinder horizontally along the rail to the desired position.
3. Tighten the locking ring by turning it clockwise.
Forward position
Position the viewfinder backwards or forwards along the camcorder axis as follows:
1. Loosen locking lever and move viewfinder support bar forwards or backwards to
suit your needs.
2. Tighten locking lever .
2.2.3 Mounting a wide angle eyepiece
If you regularly use the viewfinder at a distance, it is recommended that you fit the optionally
available wide angle eyepiece (LDK 5390/00).
To fit the wide angle eyepiece proceed as follows:
1. Hold the viewfinder’s eyepiece securely.
2. Press the button below the eyepiece tube and swing it free of the button clip .
3. Press the button above the eyepiece tube and remove the eyepiece.
4. Fit the wide angle eyepiece to the two clips ensuring that they both click into place.
3 2 1
4
1
2
3