Grass Valley DMC 1000 v.12.4 - Manual (Page 174)

174 DMC 1000 Digital Media Camcorder User’s Guide (v4.0)
Chapter 14 - Maintenance
14.4 Touch screen calibration
If the touch screen does not respond accurately to your taps you need to re-calibrate the
screen. To do this follow these steps:
1. In the viewfinder menu, go to the SYSTEM > PIN CODE > ENTER PIN menu and enter
your PIN code to set the user level to service level 1.
2. In the side panel menu, go to the SYSTEM > SIDEPANEL menu.
3. Tap the CALIBRATION button to start the touch screen calibration procedure.
4. Follow the instructions on the screen.
☞
Note
☞
Note
When the touch screen cannot be used due to misalignment, push and hold the Home push
button
on the side panel display for five seconds. The calibration settings will be reset to
their factory defaults. After resetting, perform the touch screen calibration procedure.
14.5 Cleaning the touch screen
☞
Note
☞
Note
Always turn off the camcorder before cleaning the touch screen.
Use a soft and dry cloth (preferably microfiber tissue) to clean the surface of the touch screen.
Wipe gently and do not apply strong pressure to prevent damaging the screen surface.
14.6 Messages
The messages and warnings that appear in the viewfinder (and on the home screen on the
side panel display when it is set to day or night type) are explained in the following table:
Message Description Possible action(s)
Battery low Battery capacity is low. Prepare to change or recharge
battery as soon as possible.
Battery empty Battery is empty. Switch off the camcorder
immediately and change or
recharge its battery.
External voltage low The voltage of the external power
supply is low. Switch off and check the external
power supply or replace the unit.
High power use The power usage of the camcorder
is high Prepare to switch off accessories
or power supplied external media.
Power use too high The power usage of the camcorder
is too high Switch off accessories or power
supplied external media.