Grass Valley DMC 1000 v.12.4 - Manual (Page 175)

DMC 1000 Digital Media Camcorder User’s Guide (v4.0) 175
Chapter 14 - Maintenance
Media almost full Selected storage media is almost
full. Prepare for switch-over procedure
or stop recording and change
media.
Media full Selected storage media is full. Recording continues on the next
preferred media (when available).
Current media unavailable You started a recording but the
selected media is not available.
Recording to buffer will start
instead. Insert media before the buffer is
full. Recording will continue on the
inserted media. When no media is
inserted, the camcorder tries to
record to the next preferred media.
Recording stopped When none of the selected and
preferred media is available, the
recording stops. Insert a new blank media and re-
starts recording.
Incompatible video standard The clip was recorded with a
different video standard and/or
compression. Set the camcorder to the same
video standard and compression
scheme as the clip.
Audio overload {Front, Rear 1,
Rear 2, WRX} The indicated audio source has an
overload. Signal distortion may
occur. Reduce the input level of the
indicated audio source.
System shutdown The camcorder is in the process of
switching off. Do not disconnect power supply or
battery.
Hold for standard recall Hold the button for at least two
seconds to do a standard recall.
Standard recall cancelled The standard recall button was
released within two seconds. To do a standard recall, hold the
button for two seconds.
Temp high Internal temperature is too high. Switch off the camcorder and
move the unit to a cooler place.
Replace battery Battery is depleted. Use a different battery.
Replace REV disk REV disk approaching end of life. Format REV disk or exchange the
disk with a new one.
Replace REV drive REV drive approaching end of life. The REV mechanism may need
maintenance. Contact your Grass
Valley service representative for
assistance.
Message Description Possible action(s)