Table 2-8, 1000base-x pcs with tbi pinout – Xilinx 1000BASE-X User Manual
Page 38
38
Ethernet 1000BASE-X PCS/PMA or SGMII v9.1
UG155 March 24, 2008
Chapter 2: Core Architecture
R
1000BASE-X PCS with TBI Pinout
describes the optional TBI signals, used as an alternative to the RocketIO receiver
interface. The appropriate HDL example design delivered with the core connects these
signals to IOBs to provide an external TBI suitable for connection to an off-chip PMA
SERDES device. When the core is used with the TBI, gtx_clk is used as the 125 MHz
reference clock for the entire core. For more information, see
Table 2-8:
Optional TBI Interface Signal Pinout
Signal
Direction Clock Domain
Description
gtx_clk
Input
N/A
Clock signal at 125 MHz. Tolerance
must be within IEEE 802.3
specification.
tx_code_group[9:0]
Output
gtx_clk
10-bit parallel transmit data to PMA
Sublayer (SERDES).
loc_ref
Output
N/A
Causes the PMA sublayer clock
recovery unit to lock to pma_tx_clk.
This signal is currently tied to Ground.
ewrap
Output
gtx_clk
When ’1,’ this indicates to the external
PMA SERDES device to enter loopback
mode. When ’0,’ this indicates normal
operation
rx_code_group0[9:0]
Input
pma_rx_clk0
10-bit parallel received data from PMA
Sublayer (SERDES). This is
synchronous to pma_rx_clk0.
rx_code_group1[9:0]
Input
pma_rx_clk1
10-bit parallel received data from PMA
Sublayer (SERDES). This is
synchronous to pma_rx_clk1.
pma_rx_clk0
Input
N/A
Received clock signal from PMA
Sublayer (SERDES) at 62.5 MHz.
pma_rx_clk1
Input
N/A
Received clock signal from PMA
Sublayer (SERDES) at 62.5 MHz. This
is 180 degrees out of phase with
pma_rx_clk0.
en_cdet
Output
gtx_clk
Enables the PMA Sublayer to perform
comma realignment. This is driven
from the PCS Receive Engine during
the Loss-Of-Sync state.