Xilinx 1000BASE-X - Manual (Page 73)

Ethernet 1000BASE-X PCS/PMA or SGMII v9.1 www.xilinx.com 73
UG155 March 24, 2008
Ten-Bit-Interface Logic R
Virtex-4 Devices
Method 1
The Virtex-4 FPGA logic used by the example design delivered with the core is illustrated
in
Figure 6-4 . This shows a Virtex-4 device IDDR primitive used with the DDR_CLK_EDGE
attribute set to SAME_EDGE (see the Virtex-4 FPGA User Guide). This uses local inversion of
pma_rx_clk0
within the IOB logic to receive the rx_code_group[9:0] data bus on
both the rising and falling edges of pma_rx_clk0. The SAME_EDGE attribute causes the
IDDR
to output both Q1 and Q2 data on the rising edge of pma_rx_clk0.
For this reason, pma_rx_clk0 can be routed to both pma_rx_clk0 and pma_rx_clk1
clock inputs of the core as illustrated.
Caution! This logic relies on pma_rx_clk0 and pma_rx_clk1 being exactly 180
degrees out of phase with each other since the falling edge of pma_rx_clk0 is used in place
of pma_rx_clk1 . See the data sheet for the attached SERDES to verify that this is the case.
The IDELAY elements can be adjusted to fine-tune the setup and hold times at the TBI IOB
input flip-flops. The delay is applied to the IDELAY elements using constraints in the UCF;
these can be edited if desired. See
“Ten-Bit Interface Constraints” in Chapter 12 for more
information.
Figure 6-4: Ten-Bit Interface Receiver Logic - Virtex-4 Device (Example Design)
component_name _block (Block Level from example design)
pma_rx_clk0
IBUFG
IOB LOGIC
IPAD
rx_code_group[0]
IBUF
IPAD
Ethernet 1000BASE-X PCS/PMA
or SGMII LogiCORE
pma_rx_clk0
BUFG
IOB LOGIC
pma_rx_clk1
rx_code_group0[0]
rx_code_group1[0]
rx_code_group1_reg[0]
rx_code_group0_reg[0]
IDDR
Q1
D
Q2
C
IDELAY
IDELAY