IAI America RCS3PCR-SS8C - Manual (Page 103)


11. Maintenance and Inspection
93
Peripheral openings
Center opening
Install the clearance-checking
tool instead of the slider covers.
2) Remove the stainless-sheet retainer screws on both sides and pull out the stainless sheet.
3) Guide a new stainless sheet into the slider.
4) Hold the stainless sheet in place, and affix the retainer plates and screws.
At this time, securely tighten the screws only on the motor side, and leave the screws on the counter-motor
side loose.
� How to prevent the stainless sheet from lifting
Slightly bend the stainless sheet downward near the center of the mounting holes so that the sheet can be
held securely.
5) Install the clearance-checking tool.
Sheet slider
Stainless-sheet retainer plates and screws
Securely tighten the screws only on the motor side, and
leave the screws on the counter-motor side loose.
Stainless sheet
Slightly bend the sheet
downward.
Near the center of
the mounting holes