IAI America RCS3PCR-SS8C User Manual
Page 216
0
11. Maintenance and Inspection
196
20) Loosen the screws you have only loosely tightened, move the slider back and forth 3 to 4 times by hand
(over as long an operation stroke as possible), move the slider to near the mechanical end on the motor
side, and once the slider is at a position where the motor vibration becomes the smallest, securely tighten
the screws on the motor unit.
Use an Allen wench of 3.0 mm across flats to tighten the motor screws.
* If the actuator has a brake, connect the encoder cable, plug in only the connector on the brake lead wire, and
turn on the controller power. Next, release the brake and move the slider.
To ensure safety, secure the motor unit before canceling the break release switch, and then turn off the
controller power and unplug the connector on the encoder cable.
21) Use an Allen wench of 2.5 mm across flats to connect the ground wire.
Plug in the connector.
Tightening Torque
Tightening Torque