IAI America RCS3PCR-SS8C - Manual (Page 82)


9. Options
72
9.3 High Acceleration/Deceleration Option
With this option, the maximum acceleration becomes 1.0 G (or 0.8 G on some models) instead of 0.2 G or 0.3 G
on standard specification models.
The actuator can operate at the maximum acceleration of 1.0 G (or 0.8 G on some models) while keeping the
same payload capacity as its standard specification counterpart.
To move an actuator with the high acceleration/deceleration option, a controller of high acceleration/deceleration
specification is required. This controller is different from a standard specification controller. The model number
for this option is “HA.”
9.4 Home Check Sensor
The actuator comes with a sensor that checks if the slider has actually moved to the home position as a result of
home return.
The model number for this option is “HS.”
9.5 Reversed Home Specification
When the reversed home specification is selected, the home is set on the front side. The model number for this
option is “NM.” To change the direction of home on the delivered actuator, the moving direction parameter, etc.,
must be adjusted. Consult IAI for details.
9.6 Slider Roller Specification
The slider structure is changed to the same roller structure adopted by the clean room specification.
The model number for this option is “SR.”
9.7 Slider Spacer
When the spacer option is selected for the SA4 slider, the position of the slider’s top surface becomes higher
than the motor position. The applicable code for this option is “SS.”
Actuator model
number
2-�3H7, depth 5
4-�3M3, depth 7