IAI America RCS3PCR-SS8C - Manual (Page 54)


5. Installation
Caution: 1. When the unit is installed vertically oriented, attempt to put the motor up unless there is a
special reason. Putting the motor on the lower side would not cause a problem in an ordinary
operation. However, it may rarely cause a problem, when it is not operated for a long period,
depending on the surrounding environment (especially high temperature), caused by the
grease being separated and the base oil flowing into the motor unit.
3. The actuator with the stainless sheet can be installed sideways or ceiling mount, but it must
be checked daily.
displaced. If the actuator is used continuously while the stainless sheet is slacked or
displaced, the stainless sheet may break or other problems may occur. Check the actuator
daily and if the stainless sheet is found slacked or displaced, make installation adjustmen
t
of the stainless sheet. [Refer to 11,8 “Replacing/Adjusting the Stainless Sheet.”]
2. The clean room types listed below cannot be guaranteed to meet Cleanliness Class 10 if
they are installed in the vertical orientation, the horizontally wall mounted orientation or in the
ceiling mounted orientation since they do not possess a structure to grip the stainless steel
sheet from the side cover.
Please contact us if it is necessary to install the following models in an orientation other than
the horizontal orientation.
Actuator Model : RCS2CR-SA5D, RCS2CR-SA6D
If the actuator is installed sideways or ceiling mount, the stainless sheet may be slacked or
4. There is a concern that the screw cover may get warped and interfere with a work piece for
RCS3(P)-SA8C and SA8R if they are installed in horizontally oriented wall mount or in
ceiling mount.
If the stroke exceeds 400mm, put a work piece that is to be attached away from the slider
seat surface when attaching it.
400mm or more less than 800mm
800mm or more less than 1100mm
Stroke Distance A
5mm or more
7mm or more
[Sideway installation]
[Ceiling mount installation]
A
A
60mm
60mm