IAI America RCS3PCR-SS8C - Manual (Page 107)


11. Maintenance and Inspection
97
[Procedure]
1) Remove the slider-cover affixing screws and remove the covers.
After the slider covers have been removed
2) Remove the stainless-sheet retainer screws on both sides and pull out the stainless sheet.
3) Guide a new stainless sheet into the slider.
4) Hold the stainless sheet in place, and affix the retainer plates and screws.
At this time, securely tighten the screws only on the motor side, and leave the screws on the counter-motor
side loose.
� How to prevent the stainless sheet from lifting
Slightly bend the stainless sheet downward near the center of the mounting holes so that the sheet can be
held securely.
Roller
Roller
Stainless
Slightly bend the sheet
downward.
Near the center of
the mounting holes
Stainless-sheet retainer cover mounting bolt