IAI America RCS3PCR-SS8C - Manual (Page 124)


11. Maintenance and Inspection
114
Home position
Z-phase ON
position
Mechanical end
Approx. 2 mm
The countermark on the motor
aligns with this position.
Use Parameter home return offset distance (SCON) or home
preset value (SSEL and X-SEL) to specify the settings
(The values displayed above are factory default settings).
Example: Replacement motor (IAI encoder)
Coupling (with screws)
11.10 Replacing the Motor
11.10.1 Replacing the Motor of the Motor Straight Type (Coupling Type) (Made by IAI)
: RCS2-SA4C, SA5C, SA6C
[Items Required for Replacement]
� Replacement motor � Coupling (with screws)
� Allen wrenches � Phillips screwdriver
� Scale � Oil-based marker pen
� Grease
Other than cleanroom specification
Idemitsu Kosan Daphne Eponex Grease No.2
Cleanroom specification
Kuroda Precision Industries C Grease
• PC or teaching pendant
Caution: When replacing the motor, handle the replacement motor with due care. The
actuator has been shipped with the encode adjusted to an optimal position, so do
not crush the encoder unit. It may displace the encoder, thus impairing proper
actuator operation.
[Overview of Replacement]
1) Move the slider to a position where Z-phase turns on (home position) (2 mm from the mechanical end).
Replace the motor in this position.
2) Perform homing using a PC or teaching pendant and check for deviation from the initial home position.
If there is a deviation when the SCON controller is being used, use home return offset distance to make the
adjustments. If the SSEL or the X-SEL controller is being used, use home preset value to make the
adjustments.