IAI America RCS3PCR-SS8C - Manual (Page 158)

0
11. Maintenance and Inspection
SS8C Type (For Rigid Coupling Type)
[Items Required for Replacement]
Replacement motor (with a coupling preinstalled on the
There is a cap attached as shown in the picture below for Rigid Coupling Type.
If there is no cap, it is Oldham’s Coupling Type.
Follow the procedures of replacement for Oldham’s Coupling Type stated after this instruction.
motor shaft; see the photograph on the right)
Note: Never remove the coupling.
Allen wrenches Scale Oil-based marker pen
1) Using an Allen wrench of 2.5 mm across flats, remove the bolts affixing the motor-end cap and attached
cables.
Affixing bolts at attached cable end Affixing bolts on motor-end cap
Cap