Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 10)

LabMaster 10 Zi Oscilloscopes
2
922561-00 Rev A
Safety Instructions
Observe generally accepted safety procedures in addition to the precautions
specified here to keep the instrument operating in a correct and safe
condition. The overall safety of any system incorporating this instrument is
the responsibility of the assembler of the system.
Symbols
These symbols appear on the instrument's front or rear panels and in
documentation to alert you to important safety considerations.
CAUTION of damage to instrument, or WARNING of hazard to
health. Attend to the accompanying information to protect
against personal injury or damage. Do not proceed until
conditions are fully understood and met.
HIGH VOLTAGE. Risk of electric shock or burn.
Measurement ground connection.
Safety (protective) ground connection.
Alternating Current.
Standby Power (front of MCM-Zi).
Precautions
Use proper power cord. Use only the power cord shipped with this
instrument and certified for the country of use.
Maintain ground. This product is grounded through the power cord
grounding conductor. To avoid electric shock, connect only to a grounded
mating outlet.
Connect and disconnect properly. Do not connect/disconnect probes or
test leads while they are connected to a voltage source.