Teledyne LeCroy LabMaster 10Zi Operators Manual User Manual
Page 177
Getting Started Manual
922561-00 Rev A
169
Safety Compliance
EC
D
ECLARATION OF CONFORMITY
–L
OW
V
OLTAGE
The oscilloscope meets intent of EC Directive 2006/95/EC for Product
Safety. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use -- Part 2-030: Particular
requirements for testing and measuring circuits.
The design of the instrument has been verified to conform to the following
limits put forth by these standards.
Installation (Overvoltage) Categories:
Mains Supply Connector: CAT II, local distribution level, applicable to
equipment connected to the mains supply (AC power source).
Measuring Terminals: CAT 0, signal level, applicable to equipment
measuring terminals connected to source circuits where measures
are taken to limit transient voltages to an appropriately low level.
Pollution Degree: 2, normally only dry, non-conductive pollution
occurs. Conductivity caused by temporary condensation should be
expected.
Protection Class: I, grounded equipment, protection against electric
shock is achieved by Basic Insulation and by means of a connection to
the protective ground conductor in the building wiring.
U.S.
N
ATIONALLY
R
ECOGNIZED
A
GENCY
C
ERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears UL Listing Mark
1
:
UL 61010-1 Third Edition – Safety standard for electrical measuring and test
equipment.
1
UL certification does not extend to Channel Sync Mainframe Hub and
OC910 Oscilloscope Cart.