Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 25)

Getting Started Manual
922561-00 Rev A
17
Now, connect the other end of the 1 Lane cable into the SYNC socket on the
back of the Acquisition Module.
Repeat these steps for every additional Acquisition Module in your system.
PLEASE NOTE THE FOLLOWING:

PCIe 1 Lane Cable plugs are keyed with a single groove along one
wide side of the plug. The plug must be inserted into the socket with
the groove aligned properly.

Connect to your Acquisition Modules from the correct channel
groupings on the Master Control Module; meaning, your first
Acquisition Module is connected from the CHANNEL 1-4 output,
second from the CHANNEL 5-8 output, third from the CHANNEL 9-12
output, etc.

If you are connecting less than 5 Acquisition Modules, the PCIe 1
Lane Channel Sync Outputs on the back of the Master Control
Module may not be skipped and must be connected in consecutive
order into the PCIe 1 Lane Channel Sync Inputs on the back of the
corresponding acquisition modules.

Pull gently on the green pull tab on the cable plug for removal.