Teledyne LeCroy LabMaster 10Zi Operators Manual User Manual
Page 52
LabMaster 10 Zi Oscilloscopes
44
922561-00 Rev A
Stop - Press to prevent the oscilloscope from triggering on a signal. If
you boot up the instrument with the trigger in Stop mode, the
message "no trace available" is shown.
Trigger Setup - Press to open the Trigger Setup... dialog. Corresponds
with screen menu selection: Trigger → Trigger Setup....
Q
UICK
A
CCESS
P
ROCESSING
F
UNCTIONS
The Processing section allows you to suspend your system from processing
data. You can stop data processing, make adjustments, and then resume
data processing with the touch of two on-screen buttons.
Touching the Stop button shows the Processing Paused... pop-up.
Touch the Resume button to continue processing data.
Q
UICK
A
CCESS
U
NDO
F
UNCTION
At times, an Undo button is made available to the right of the Quick Access
Toolbar on the Menu Bar. The Undo button is labeled with the most recent
action, so you are aware of the specific function prior to reversal.