Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 150)

LabMaster 10 Zi Oscilloscopes
142
922561-00 Rev A
Saving and Recalling Waveforms
Saving Waveforms
The Save Waveform dialog is used to save displayed waveforms to either a
memory trace or to text or binary file formats.
Access the Save Waveform dialog by either selecting File → Save Waveform
from the menu bar or clicking the Save Waveform button on the main
Save/Recall dialog.
Use the sections of this Save Waveform dialog, which correspond with the
following explanations, to properly save your waveform(s).
1. Select either Memory or File by touching either respective button on
the Save To portion of the dialog.
NOTE : When Memory is selected, only Source and Destination controls are
shown on the Save Waveform dialog. When File is selected, many more
controls are available.
2. Touch the Source control and select a source from the Select Source
pop-up. The source can be any trace; for example, a channel (C1–C4),
math function (F1–F4), or a waveform stored in non-volatile RAM
(M1–M4).
To align all sample points on waveforms (required for export to
MATLAB), mark the SYNC all channels checkbox that appears below
the Source field.
3. Destination - Click to show the available memory traces when saving
to memory.
4. Touch inside the Trace Title data entry control to change the default
name of your waveforms (if desired).
CAUTION. By design, the first waveform is automatically
numbered 0, the second 1, and so forth. If you use waveform