Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 125)

Getting Started Manual
922561-00 Rev A
117
6. Touch #Values and enter the number of parameter values that will
be contained in the histogram.
7. Touch #Bins and enter the number of bins that comprise the
histogram. This determines how many bars appear in the histogram.
8. To let the oscilloscope position the histogram, check Enable Auto
Find, then touch the Find Center and Width button.
OR
TouchCenter and Width and enter values.
C REATING A M ATH H ISTOGRAM
1. Choose Math → Math Setup... from the menu bar to access the
Math dialog.
2. If the function for which you want a histogram exists, turn it On and
touch the Fx tab to open the Function dialog.
If the function does not yet exist, first follow steps in Math Setup (on
page 112), then open the Function dialog.
3. Touch the Graph button on the Function dialog. The histogram of the
function now replaces the original function trace on the Fx grid.
4. If you do not see a resulting histogram (i.e., you see a track or trend),
touch Graph with: and choose Histogram from the pop-up menu.
5. Touch the Histogram tab at the right to display the Histogram right-
hand dialog.