Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 153)

Getting Started Manual
922561-00 Rev A
145
1. Select either Memory or File by touching either respective button on
the Recall From portion of the dialog.
NOTE : When Memory is selected, only Source , Destination , and Show
on recall controls are shown on the Recall Waveform dialog. When File is
selected, many more controls are available. Regardless, the controls are
used as explained in the following steps.
2. If recalling from Memory, touch inside the Source control and select
a source stored in non-volatile RAM (M1–M4) from the Select Source
pop-up.
3. Touch inside the Destination control and select a location for storage
(memory or file) from M1 to M4.
4. Show on Recall - Mark this checkbox to have the memory trace
shown on the grid display after recalling the waveform.
5. When saving a File, touch inside the Show only files control and
select an area to limit the search (channels, math functions, or
memory).
6. Touch inside the Recall files from directory data entry control and
provide the path. You can also touch the Browse button and navigate
to the file. Touch inside the Next file will be recalled from data entry
control and provide the path or, touch the Browse button to navigate
to the file.
7. Up /Down arrows - Use these buttons to cycles through files in the
selected folder from the Show only files control.
8. When finished, touch the Recall Now! button.