Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 43)

Getting Started Manual
922561-00 Rev A
35
5. Tighten the V-male connector around the female-female barrel
adapter using the torque wrench in a counterclockwise motion.
CAUTION. Hold the torque wrench at the end or you may apply too
much force. When the torque wrench bends at the moment arm, it
is tightened to the right amount of force. Do not tighten further.
6. Connect a cable to the barrel adapter, and use the torque wrench to
tighten it.
To remove the female-female barrel adapter: Reverse the steps above,
turning the V-male connector clockwise to loosen it. Be sure to turn the V-
male connector and not the barrel adapter. You may have to manually keep
the torque wrench from bending while loosening the connector.
Probe Dialog
Teledyne LeCroy proprietary probe interfaces provide a complete
measurement solution from probe tip to oscilloscope display. The Probe
Dialog displays probe attenuation and other information, and allows you to
make tip select and other probe settings from the oscilloscope touchscreen.
The following figure shows a typical channel dialog on a Teledyne LeCroy
oscilloscope containing both 2.92 mm (Input A) and 1.85 mm (Input B)
interfaces. The input selection is on the left-hand side of the dialog box.