Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 109)

Getting Started Manual
922561-00 Rev A
101
Zooming a Single Channel
The Zoom button appears as a standard button at the bottom
of the channel Cx Vertical Adjust setup dialog for you to create
a zoom trace of your input waveform.
1. On the menu bar, touch Vertical → Channel X Setup....
OR
Touch the channel trace descriptor label for a displayed channel.
2. Touch the Zoom at the bottom of the Cx Vertical Adjust dialog. A
zoom trace (one of Z1 to Z4) is created for the selected channel.
3. Vary the degree of zoom by touching the newly created Zx trace
label. The setup dialog for the zoom (Z1 to Z4) opens. It shows the
current horizontal and vertical zoom factors.
4. To increase or decrease your horizontal or vertical zoom
in small increments, touch the Var. checkbox to enable
variable zooming. Now with each touch of the In/Out
control buttons, the degree of magnification changes by
a small increment.
OR
To zoom in or out in large standard increments with each touch of
the zoom control buttons, leave the Var. checkbox unchecked.
OR
To set exact horizontal or vertical zoom factors, touch inside the
Horizontal Scale/div data entry control and provide a time-per-div
value using your preferred input control method. Additional
information on using the touch screen controls can be found in the
Dialog Area. Then touch inside the Vertical Scale/div control and
enter a voltage value.
To reset the zoom to x1 magnification, touch Reset Zoom in the dialog.
You can also use the Zoom and Math front panel knobs to adjust the
horizontal and vertical zoom.