Teledyne LeCroy LabMaster 10Zi Operators Manual User Manual
Page 73
Getting Started Manual
922561-00 Rev A
65
4.
If you want to increase or decrease your horizontal or vertical zoom
in small increments, touch the Var. checkbox to enable variable
zooming. Now with each touch of the zoom control
buttons, the degree of magnification changes by small
increments.
OR
To zoom in or out in large standard increments with each touch of
the zoom control buttons, leave the Var. checkbox unchecked.
OR
T set exact horizontal or vertical zoom factors, touch inside the
Horizontal Scale/div data entry control and enter a time-per-div
value, using the pop-up numeric keypad. Then touch inside the
Vertical Scale/div control and enter a voltage value.
D
ISPLAYING AN
I
NDIVIDUAL
S
EGMENT
1.
Touch Math → Math Setup... on the menu bar.
2.
Touch a function tab Fx showing its corresponding dialog.
3.
On the dialog, touch inside the Operator1 control and select the
Segment button from the pop-up menu.
4.
In the dialog on the right, touch the Select tab.
5.
Touch inside the First Selected data entry control and select the first
segment you want to display. Use the same method to provide a
value in the Number of Selected data entry control.
NOTE
: In Persistence mode, the segments are automatically overlaid one on top of
the other in the display. In non-Persistence mode, they appear separately on the
grid.