Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 106)

LabMaster 10 Zi Oscilloscopes
98
922561-00 Rev A
Setup All Input Channels at Once
1. Touch the All Locked button.
2. Touch one of the Mode buttons.
3. Touch the Show last trace checkbox if you want the last trace
displayed.
4. Touch inside the Saturation data entry control and provide a whole
number integer.
5. Touch inside the Persistence time data entry control and make a
selection from the pop-up menu.
Setup Each Input Channel Individually
1. Touch the Per Trace button.
2. Touch one of the persistence mode buttons next to an input
channel.
To refine the settings, touch the tab to set up persistence for that
channel.
3. Touch one of the mode buttons.
4. Touch the Show last trace checkbox to display the last trace.
5. Touch inside the Saturation data entry control and enter a whole
number integer,.
6. Touch inside the Persistence time data entry control and make a
selection from the pop-up menu.
7. To return all input channel setups to their default settings, touch
the Reset All button.