Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 136)

LabMaster 10 Zi Oscilloscopes
128
922561-00 Rev A
Mask Testing
Users may load or create a pixel-based mask on the display grid using a
variety of methods. Test conditions can be set, and a pass/fail result
returned based on whether the condition was found to be true or false. The
source of the mask is always a trace (Channel, Zoom, Math waveform).
Creating a Mask
1. Choose Analysis → Pass/Fail to display the Pass/Fail dialog.
2. Touch the Q1 button .
3. Select Mask Test from the popup. Now, the Q1 dialog is shown and
shows the Mask test condition selected.
With the Mask test Pass Fail Condition selected, the Test, Load Mask,
Make Mask, and Gate right-hand dialogs are displayed. On these, you
manage, make, and apply gates to your mask.