Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 151)

Getting Started Manual
922561-00 Rev A
143
name <XYZ>32 but it is not preceded by waveforms <XYZ>0 through
<XYZ>31, the next number in the sequence is appended to 32. If you
need to use a number in your waveform name, append an alpha
character at the end of the number: XYZ32a. You can then search on
that character and rename the files later.
5. If you are saving to a file, touch the Data Format control and select a
format type.

Binary - saves the file to Teledyne LeCroy's binary file format.
This format is documented in various Remote Control Manuals
for Teledyne LeCroy Oscilloscopes. Selecting Binary results in
the smallest possible file size, and is recommended when
recalling waveforms to Teledyne LeCroy instruments.
NOTE : Binary files can be converted to ASCII using Teledyne LeCroy
utilities such as ScopeExplorer or WaveStudio.

ASCII -Text output file (.txt extension)

MATLAB - Text output file compatible with MATLAB (.dat
extension)

Excel - Text output file compatible with Excel (.csv extension)

MathCad - Text output file compatible with Excel (.prn
extension)

Audio - .wav format

WaveML - enables XML output, used for persistence traces
6. Depending on your selection, you may need to touch the SubFormat
control and select a subformat.

Word - Available when selecting the Binary format, specifies
the samples in the output file are represented with 16 bits.
Always use this option unless Byte mode is pre.

Byte - Available when selecting Binary format, specifies the
samples in the output file are represented with 8 bits.
Note : This option can result in a loss of output file resolution.