Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 33)

Getting Started Manual
922561-00 Rev A
25
Touch Screen and External Displays
You may operate the instrument using the built-in touch-screen or attach an
external monitor for extended desktop operation. A properly configured
external touch-screen monitor will take on all the touch-screen capabilities
of the internal display.
NOTE: If the external monitor uses a Fujitsu touch screen driver, it will not work as a
touch screen but will support extended desktop operation.
To connect to an external monitor:
1. Choose File > Exit to close the oscilloscope application so that the
Windows desktop is visible (you do not need to shut down
completely).
2. Connect the oscilloscope to the external monitor from the DVI-D
video output connector.
3. Right-click on the desktop to display the settings menu, then choose
Screen Resolution.
4. On the Windows display dialog:

Select display number 2 (the external monitor) and choose
Multiple displays: Extend this display.

Drag the display number 2 icon to its location in your setup
(above or below the oscilloscope display).

Make any other desired display selections, then touch
Apply and OK.
5. Use the Start DSO desktop icon to restart the oscilloscope
application.
6. Choose Display > Display Setup.
7. On the Display setup dialog, check Extend Grids on 2
nd
Monitor.
The total number of grids is now distributed over both displays.