Teledyne LeCroy LabMaster 10Zi Operators Manual - Manual (Page 55)

Getting Started Manual
922561-00 Rev A
47
(DSQ), coupling (DC/GND), bandwidth limiting (BWL), and averaging (AVG).
These indicators have a long and short form, respectively.
The long and short forms of trace descriptor indicators.
Besides channel traces, math and parameter measurement labels are also
displayed. Labels are displayed only for traces that are turned on.
Vertical and horizontal trace descriptor (labels) are displayed below the grid.
They provide a summary of your channel, timebase, and trigger settings.
Make vertical or horizontal channel adjustments by touching the respective
label. The setup dialog for the function is shown beneath.
TimeBase trace descriptor labels show the trigger
delay setting, time per division, and sampling
information.
Trigger trace descriptor labels show the trigger mode
(Auto, Normal, or Stopped). It also shows the coupling
(DC), trigger type (Edge), source (C1), level (0 mV), and
slope (Positive).
Setup information for horizontal cursors,
including the time between cursors and
the frequency, is shown beneath the TimeBase and Trigger trace descriptor
labels.