Connecting the spo, Sensor – ZOLL Propaq M Rev B User Manual
Page 102
Advertising
C
HAPTER
9 M
ONITORING
P
ULSE
O
XIMETRY
(S
P
O2)
9-6
www.zoll.com
9650-0803-01 Rev. B
Connecting the SpO
2
Sensor
To connect the SpO
2
sensor to the Propaq M unit:
1. When using a sensor extension cable, inspect the cable before use. Replace the cable if it
shows any signs of wear, breakage, or fraying. Plug the sensor extension cable into the SpO
2
socket on the side of the Propaq M unit:
Figure 9-1 Connecting the SpO
2
Sensor to the Propaq M Unit
2.
Lift the clear plastic protective cover from the female end of the extension cable, then plug
the sensor cable’s male connector into the extension cable connector -- make sure that the
plug is all the way into the connector:
Figure 9-2 Plug the Sensor Connectors Together
Advertising