Uploading data from a compact flash card, Procedure, Install new software to the unit – ZOLL R Series Monitor Defibrillator Rev K CONFIGURATION User Manual
Page 12: Copy a second language to the unit
Chapter 1
Introduction
6
9650-0902-01 Rev. K
Uploading Data from a Compact Flash Card
You can upload data from a compact flash card to perform the following tasks:
•
Copy the configuration of one unit to any number of units
•
Install new software to the unit
•
Copy a second language to the unit
Procedure
Follow these steps to load a configuration, another language, or software from a compact flash
card:
If you want to review configuration settings, press the Change Config softkey. See “Accessing
and Changing Configuration Settings” on page 10 for more information. If you want to leave
Step
Action
1.
Install the compact flash card in the R Series unit,
and power on the unit in System Configuration mode
as described in “Entering System Configuration
Mode” on page 2.
2.
Press the Read From Card softkey to display the
Read Card screen.
Use the Prev Value and Next Value softkeys to
toggle the highlighted area between the following
options:
•
LANGUAGE - allows you to upload a second
language to the unit. English is always on the
unit as default, and one other language can be
added.
•
CONFIGURATION -allows you to read the
configuration data from a card, thereby
configuring this unit.
•
PROGRAM - allows you to install new software
in either the PD processor or the ECG processor.
Note:
Do not install an older version of software
over a newer version because it will cause
software problems.
3.
Press the Enter softkey to initiate reading and
storing the information from the installed compact
flash card.
Once the card has been read and loaded, the unit
displays the CARD READ message (for a language
card) or the CARD READ and PRESS CHANGE
CONFIG TO VIEW messages (for a configuration
card).
System Configuration
Change
Config
Exit
Config
Read
From
Card
Restore
Defaults
Enter
Next
Value
Prev
Value
System Configuration
Read Which Type of Card?
LANGUAGE
CONFIGURATION
PROGRAM
System Configuration
Card Read
Press Change Config to View
Change
Config
Exit
Config
Read
From
Card
Restore
Defaults