ZOLL R Series Monitor Defibrillator Rev K CONFIGURATION - Manual (Page 16)

Chapter 1 Introduction
10 9650-0902-01 Rev. K
Accessing and Changing Configuration Settings
You can change the current value for any configuration setting. You access most of the settings
in the same way as described below. Additional steps are required to access and modify several
settings. For those settings, the additional steps are provided with the setting description in the
next chapter.
Procedure
Follow these steps to access the settings.
Step Action
1. Press the Change Config softkey from the Main
System Configuration screen.
The unit advances to the Select Configuration
Category screen.
2. Use the softkeys on the screen to move through
the list and select a category, or to exit as
follows:
•

— moves the highlight up, down,
left, and right through the list of categories.
• Enter — provides you access to the options
of the highlighted category. Press this softkey
once you have highlighted the appropriate
category.
• Main Menu — returns you to the Main
System Configuration screen.
3. Once you select and access the options for a
category, you can highlight the specific setting
you want to change, then press the Change
Value softkey until the appropriate value is
displayed.
Note: Some options require and evoke an
additional screen to set the value (for
example, setting the Device Identifier).
Specific instructions for those options
are provided in the next chapter.
Enter
System Configuration
Select Configuration Category
Set/Review
Main
Menu
General
ECG
Audio
Basic Defib
Advisory Defib
CPR
Pace
Alarms
Display
Printer & Report
Page 1 of 2
Enter
System Configuration
Select Configuration Category
Main
Menu
Readiness Test
AED Mode
NIBP
EtCO2
Wi-Fi
Page 2 of 2