Subnet mask, Procedure, Follow these steps to set up a subnet mask – ZOLL R Series Monitor Defibrillator Rev K CONFIGURATION User Manual
Page 62: Use the softkey as follows
Chapter 2
Configuration Settings
56
9650-0902-01 Rev. K
Subnet Mask
This setting allows you to specify the subnet mask used in the static configuration.
Note:
This setting is accessible only when DHCP/Static IP is set to Static IP.
Values are as follows:
Procedure
Follow these steps to set up a subnet mask.
Possible Values:
XXX.XXX.XXX.XXX where XXX is 000 to 255
Default:
255.255.255.000
Step
Action
1.
From the Select Configuration Categories screen,
select Wi-Fi, then press the Enter softkey.
The Wi-Fi Configuration screen appears.
2.
Press the Next Item softkey until Subnet Mask
appears and press the Change Value softkey.
The Set Subnet Mask screen appears.
3.
Use the softkey as follows:
•
— moves the highlight left and right
through the character selection table.
•
Enter Char — enters the highlighted
character for each digit of the subnet mask.
•
Return — returns you to the Wi-Fi
Configuration screen. Press the Return
softkey when you are finished entering the
subnet mask.
Next
Item
Prev
Item
System Configuration
Wi-Fi Configuration
Defib History
Transfer Mode
DHCP/
Static IP
Both
Static IP
Main
Menu
Exit
Config
Category
List
Change
Value
Full Disclosure
Transfer Mode
Server
Page 1 of 7
System Configuration
Set Subnet Mask
255.255.255.000
Return
Enter
Char
1
Cancel
4
7
2
5
8
3
6
9
0
<
<
.