Printer & report settings, Set report restart delays, Auto generate strips – ZOLL R Series Monitor Defibrillator Rev K CONFIGURATION User Manual
Page 54: Print 3 leads when leads sel
Chapter 2
Configuration Settings
48
9650-0902-01 Rev. K
Printer & Report Settings
The Printer and Report Config settings are attributes that control what and how things are
printed:
•
Set Report Restart Delays
•
Auto Generate Strips
•
Print 3 Leads When Leads Sel.
Note:
Printing is not available in AED mode.
Set Report Restart Delays
This setting allows you to review or change the length of time the device must be turned off
before it automatically erases all summary report and full disclosure data.
Values are as follows:
Auto Generate Strips
This setting allows you to set the strip chart recorder to automatically begin printing after a
defibrillator discharge or whenever alarms are triggered while in Manual mode.
Values are as follows:
Print 3 Leads When Leads Sel.
This setting allows you to specify whether or not the strip chart recorder prints three (3)
simultaneous leads of the patient ECG when Leads are selected and a 5- lead cable is in use.
Values are as follows:
Possible Values:
5 Min, 15 Min, 30 Min, 90 Min, 6 Hours, 1.5 Days, Manual
Default:
90 Min
Possible Values:
Yes, No
Default:
Yes
Possible Values:
Yes, No
Default:
No