Yokogawa DAQWORX - Manual (Page 147)

6-20 IM WX104-01E
Message drecton
Set the display direction of messages to [Horizontal] or [Vertical]. When the trend is set
to Vertical, the message direction is fixed to [Horizontal].
Scale Dgt
Select the [Normal] or [Fine].
Fine If the scale value is two-digit display, it can be changed to three digits. For
example, if the scale range is “49.0 to 51.0,” the scale values are displayed using 3
digits as shown below.
Value Indcator
The current value is displayed as a mark or a bar graph.
Full Crcle Acton
Settngs Descrpton
Allclear Clears the entire waveform when one revolution of waveform is recorded and
continues the recording of the next revolution.
Divclear Clears one division of the old waveform when the remaining amount of
waveform to be recorded falls to one division and continues the recording.
Trend Lne
Set the line width of the trend in dots (1 to 3).
Grd
Select the number of grids to be displayed in the waveform display area of the trend
display.
Settngs Descrpton
4 to 12 Displays a grid that divides the display width into 4 to 12 sections.
Auto Displays the same number of grids as the number of scale divisions of the
first assigned channel of the group.
Bar Graph Drecton
Select Bar graph direction.
Brghtness
Select a value from 1 to 6 (2 by default). Larger the value, brighter the display becomes.
Backlte Save Mode
Settngs Descrpton
Off Disables the backlight saver.
Dimmer Dims the display if there is no operation for a given time.
Timeoff Turns the backlight OFF if there is no operation for a given time.
Backlght Saver Tme
Select a value from 1 min to 1 h. If the specified time elapses without any key operation
or alarm occurrence, the LCD backlight switches to the specified mode.
Backlght Restore
Settngs Descrpton
Key The backlight returns to the original brightness when a key is pressed.
Key&Alarm The backlight returns to the original brightness when a key is pressed or
when an alarm occurs.
Trend Background
Set the background color of the operation screen to White (default setting) or Black.
6.4 Enterng General Settngs