Index, Openng the dx/mv/cx folder, Extng the daq desktop – Yokogawa DAQWORX User Manual
Page 24
2-5
IM WX104-01E
1
2
3
4
5
6
7
8
9
Index
Us
ng the DAQ Desktop
Openng the DX/MV/CX Folder
2. The DX/MV/CX folder opens.
DX/MV/CX folder
Start/Stop the data acquisition (section 2.2)
Data monitor (section 3)
Send a trigger (section 2.2)
1. Double-click here.
Create and View the automatic
destination folder (section 2.5)
Check and reconfigure
DX100/DX200/MV100/MV200/CX1000/
CX2000/DX1000/DX2000/MV1000/MV2000
setup data
(section 5, section 6, section 7, section 8)
Confirm data (section 2.4)
Snap shot (section 2.3)
Extng the DAQ Desktop
If you attempt to exit the program while the Data Monitor, Data Viewer, or Configurator is
running and the desktop is busy carrying out some operation, a message “Now working!
Do you exit all compulsory?” is displayed.
Note
You cannot exit from the DAQ Desktop, if you are editing a file that is outside the management
of the DAQ Desktop on the Data Viewer that was started from the Start menu or on the
Configurator program.
2.1 Startng and Extng the DAQ Desktop