Yokogawa DAQWORX - Manual (Page 248)

7-52 IM WX104-01E
SNTP Clent
• Use
Select [Use] to use the SNTP client function; Otherwise, select [Not]. If you select [Use],
the SNTP client settings are displayed.
• Server Name
Set the SNTP server name using up to 64 alphanumeric characters.
• If the DNS is used, you can set the host name as a server name.
• You can also set the IP address. In this case, the DNS is not required.
• Port No.
Enter the port number of the file transfer destination SNTP server in the range of 1 to
65535. The default value is 123.
• Access Interval
Set the time interval for synchronizing the time with the server to OFF, 1, 8, 12, or 24h.
If you select OFF, you can synchronize the time manually by operating soft keys. The
time is not synchronized if the difference in the time between the MV and the server is
greater than or equal to 10 minutes.
• Ref. Tme
Set the reference time for making queries.
• Access tmeout
Set the time to wait for the response from the SNTP server when querying the time to
10, 30, 90s.
• Tme adjust (start)
Select [On] to synchronize the time using SNTP when memory start is executed;
Otherwise, select [OFF].
7.5 Enterng Basc Settngs