Yokogawa DAQWORX - Manual (Page 26)

2-7 IM WX104-01E
1
2
3
4
5
6
7
8
9
Index
Us
ng the DAQ Desktop
When the Multbatch Functon Is Included
Select one item for recording or math start,
fill in the text boxes, then click the
Start button.
Shows the batch information set on
the DX1000/DX2000 (release number 3 or later)
Green indicates batches that have started
Shows the batch number
Shows the lot number
After selecting the batch number or computation to start, enter the batch number,
lot number, and comments if necessary. If you select individual batch numbers and
computations before clicking either the Memory & Math Start, Memory Start, or Math
Start button, these items will be much clearer.
Batch No.: Up to 32 alphanumeric and the following characters can be entered: %()+-.
°_@[].
Square brackets [ ] can be used with DX1000/DX2000 release 3 or later.
Lot No.: Up to 8 alphanumeric characters can be entered. The number of
characters that can be entered depends on the number of digits of the lot
number set on the DX/MV/CX.
Comment: Up to 50 characters per line can be input. Alphanumerics and some
symbols can be entered.
Note
• If starting and stopping is carried out on the DX/MV/CX, and in other cases, the start/stop
status display may not be correct.
• If the Batch function is ON, batch information cannot be input when the connected
instrument has started memory sampling. Also, the Memory & Math Stop and Memory Stop
buttons are not available.
2.2 Startng and Stoppng Data Acquston on the DX/MV/CX, Send a Trgger