Yokogawa DAQWORX - Manual (Page 51)

3-16 IM WX104-01E
3.4 Dsplayng Numerc Values
Dsplayng Numerc Values
1. Click here ([Window] - [Numeric Monitor]).
Connect/Disconnect the monitor (section 3.8, 3.10)
Select the displayed group
Pause the monitor (section 3.9)
Turn ON/OFF the link (section 3.9)
Turn ON/OFF the alarm display
General display settings
Characters used to identity channels (section 3.2)
Display the bar representing
the current measured value
Display the current measured
value numerically
Display the channel No.,
tag No., or tag comment
2. The numeric monitor opens.
Alarm display (Displays the
conditions of alarm 1, 2, 3,
and 4 from the left)
General Dsplay Settngs
The parameters in the [General Display Settings] dialog box related to the numeric
display are as follows:
• Turn ON/OFF waveform display
• Registering the channel
• Setting the displayed range: The bar representing the current measured value
is displayed by normalizing it to the minimum and
maximum values of the scale.
For details related to the setting procedures, see “General Display Settings” in section 3.2,
“Displaying the Trend.”
Turn ON/OFF the Alarm Dsplay
The alarm conditions of alarms 1 to 4 are displayed on the screen by clicking the alarm
display icon or selecting [View] - [Alarm] and turning ON the alarm display. When an
alarm is in effect, the indicator is red. When it is not, the indicator is green. If the alarm
is not set, the indicator is black.
Settng the Wndow
For details, see “Setting the Window” in section 3.2, “Displaying the Trend.”
Note
For the numeric display of abnormal data, see page 3-12.