Serial communication settings, Modbus master settings, Serial communication settings -64 – Yokogawa DAQWORX User Manual
Page 321: Modbus master settings -64, Seral communcaton settngs, Modbus master settngs
Advertising
8-64
IM WX104-01E
Seral Communcaton Settngs
When using serial communications between the CX and other devices, set the
parameters required for serial communications. In the [Protocol] settings, if [MODBUS
MASTER] is selected, you must to click the [Modbus master] tab and make Modbus
master settings.
Click this tab
Modbus Master Settngs
When using the CX as a Modbus master, enter the Modbus master basic and command
settings. For details about the settings.
Click this tab
8.11 Network Settngs
Advertising
This manual is related to the following products: