Yokogawa DAQWORX - Manual (Page 192)

6-65 IM WX104-01E
1
2
3
4
5
6
7
8
9
Index
Conf
gur
ng the DX1000/DX2000
6.6 Sendng the Setup Data to the DX1000/DX2000
The method used to send the data varies depending on whether a CONFIG file or setup
data file is being transmitted.
CONFIG fle
The following two methods are available:
• Selectng from the toolbar
The setup data are sent when [File] - [Store] is selected.
• Clckng the [X] button
When the Configurator is closed by clicking the [×] button, a confirmation dialog box is
displayed.
To send the new setup data to the DX1000/DX2000, click the [Yes] button.
Otherwise, click the [No] or [Cancel] button.7
If the DX1000/DX2000 is acquiring data to the memory, a message “Now Memory
& Math sampling. Can’t store setting” is displayed. The data will not be sent in this
case.
Setup data fle
DX1000/DX2000 folder
1. Stop the data acquisition to the memory.
2. Drag and drop the file onto the CONFIG
icon of the DX1000/DX2000 folder
The contents of the setup data file (*.PDL) located on the DAQ Desktop can be
transmitted. If the DX1000/DX2000 is acquiring data to the memory, the data will not be
sent in this case.
Note
Of the network settings in the Basic Setting tab, the following items are not sent.
• Settings under [Ethernet] > [TCP/IP] and [Server functions].
• All settings under [Serial] > [Serial].