Yokogawa DAQWORX - Manual (Page 260)

8-3 IM WX104-01E
1
2
3
4
5
6
7
8
9
Index
Conf
gur
ng the CX1000/CX2000
• Option
The following options can be selected if you set the style to Style2 or earlier. They are
not available on Style 3 or later, because they are equipped as standard.
• Green Series Comm
Select whether a communication option with an external Green Series controller is
available. This option is valid only when [Serial] is set to [RS-232] or [RS-422/485].
If [LOOP] is set to [0LOOP], the option is fixed to [Green Series Comm].
• Ladder Comm
Select whether a ladder communication option is available. This option is valid only
when [Serial] is set to [RS-232] or [RS-422/485].
This option is invalid if [LOOP] is set to [0LOOP].
• Remote
Select whether a remote option is available. This option is valid only when [Alarm
Relay] is set to [4p+With Fail/Mem. End] or [6p].
• Program
Select the program control option: [None], [Program Num#:4], or [Program Num#:30].
If the system configuration is changed and the [OK] button is clicked, a message
“System Configuration is changed Input&Data are Initialized” appears. Click the [OK]
button to initialize the data.
Note
In the procedure for the System Configuration dialog box, make sure that the CX tab is selected
before entering settings. If the DX tab is selected, the settings you enter will apply only to those
instruments.
Select [File]-[New] to create
new setup data from the second time.
Create the setup data according to step 2 and 3.
Openng the CX Confgurator by Loadng Exstng Setup Data
Select [Open] from the [File] menu on the CX Configurator, specify the location of the
setup data file in the [Open] dialog box, and open the CX Configurator.
2. The [Open] dialog box opens.
1. Click the open file button or
[Open] on the [File] menu.
Select a file with .pcl extension
and click here.
8.1 Startng the Hardware Confgurator (Openng the Hardware Confgurator Wndow)