HP Remote Assistant Card - Manual (Page 154)

C Modem Commands
136
Command Values Def Description
L7 L7 lists additional parameters.
#Ln n = 0 thru 3 *** #L0 means modems negotiate V.42 Mode.
#L1 means MNP on and LAP-M off.
#L2 means LAP-M on and MNP off.
#L3 means no detection phase but go directly to LAP-M.
Mn n = 0 thru 3
***
M0 means Monitor speaker always Off.
M1 means Monitor speaker On until carrier detected.
M2 means Monitor speaker always On.
M3 Monitor speaker on during dialing/off during handshaking.
$MBn n = speeds
***
$MB75 selects CCITT V.23 mode.
$MB300 selects 300 bps on-line.
$MB1200 selects 1200 bps on-line.
$MB2400 selects 2400 bps on-line.
$MB4800 selects 4800 bps on-line.
$MB9600 selects 9600 bps on-line. (default for Belgium)
$MB14400 selects 14400 bps on-line.
O Exit Command Mode and go into On-Line Mode.
P
(Not
applicable in
Denmark)
*** Modem will pulse-dial numbers following the P.
&Pn
(Not
applicable in
the U.K.)
n = 0, 1 or 2 *** &P0 means 60-40 pulse ratio.
&P1 means 67-33 pulse ratio.
Qn n = 0 or 1 *** Q0 means Result Codes sent.
Q1 means Result Codes will be suppressed (quiet).
Q2 means Dumb Answer Mode.
&Qn n = 0 or 1 *** &Q0 selects Multi-Tech command set.
&Q1 selects AT command set.
Rn n = 0 or 1 *** R0 means modem will not reverse modes.
R1 means modem will reverse modes.