HP Remote Assistant Card User Manual
Page 93
3 Server Software Installation and Configuration
75
•
ASRSRVC.EXE
This ASR service program resets the ASR hardware via calls to the ASR driver.
The polling period is 30 seconds by default. It may be reconfigured by the user via
the ASRUSER program.
•
ASRUSER.EXE
This program runs from an NT DOS command prompt. It is used to load the ASR
service program, change time-out parameters, and get ASR statistics. It accepts
the following command line options:
/g
Loads the ASRSRVC service program and then starts it.
/l
Loads the ASRSRVC service program and the ASRDEV driver if not
already loaded. By default, the service program and the driver load
automatically. Use this option only if you change the registry
configuration to load ASR manually (that is, on demand).
/u
Disables ASR by unloading the ASRSRVC service program. The ASR
service may be stopped at any time by the administrator running
ASRUSER /u. Terminating the ASR service program in this manner
does not affect the registry configurations. If the registry configurations
are set to load the driver and service programs automatically, these
programs are automatically loaded when the system is restarted.
/s
Starts the ASRSRVC service program (loads it if not loaded)
/x
Stops the ASRSRVC service program (without unloading it)
/t
Changes the ASR hardware restart time--the time after which the
system automatically restarts if the ASR hardware timer is not reset by
the service program. This value is preset to 600 seconds (10 minutes).
If the service program is not able to execute for 10 minutes (indicating
a hung system), the system automatically restarts via ASR hardware.
You may reconfigure the restart time in the range 300 seconds (5
minutes) to 1800 seconds (30 minutes) by running ASRUSER /t. The
change will remain in effect even after restarting your system.
/p
Changes the ASR service program polling period--the time interval at
which the ASR service program resets the ASR hardware timer. It
must be less than the automatic hardware reset time (pre-configured to
30 seconds). The service program resets the hardware timer every 30
seconds. To change this time, run ASRUSER /p. The value must be
less than the value entered for the Automatic Hardware Restart time.
/o
Gets the current ASR time-out and polling period
/v
Gets the version number