HP Remote Assistant Card - Manual (Page 29)

1 Introduction
11
Upgradeable firmware. The HP Remote Assistant Management Program is stored in
Flash ROM on the HP Remote Assistant board. If it is necessary to upgrade the
firmware, a newer revision of the code may be downloaded to the programmable
ROM. When available, new firmware versions can be obtained via the HP PC Bulletin
Board System (BBS), on the FTP server, or from HP Support.
HP Remote Assistant System Requirements
Minimum server requirements:
•
Any HP NetServer system with an available EISA slot.
NOTE The HP Diagnostic Assistant software described in this manual does not
support HP NetServer LE or LM.
•
Modem or direct connection via the RS-232 port. You can use either the on-board
modem (Model D2968C or D2969C), or an external modem. See HP supported
modems listed in Appendix B.
•
An HP NetServer Navigator Utility Partition, or 8 MB of disk space available in a
bootable DOS Partition installed on the hard disk (required for remotely running
the EISA Configuration Utility, DOS file transfers, and Diagnostic Assistant.
•
An HP NetServer Navigator CD-ROM Version E.02.00 or later. (Check the
version number printed on the CD-ROM opposite the HP logo.)
•
200 KB (maximum) of disk space on NOS partition for agents and drivers
NOTE For NT Graphics Console Redirection, you must have Windows NT 3.51
with 16 MB of available disk space.
Supported Network Operating Systems include:
•
Novell NetWare v3.12, and v4.1 (including SMP, excluding SFT III)
•
Microsoft Windows NT Server 3.5 and 3.51
•
IBM OS/2 2.1, 2.11 (SMP) and Warp version 3.0
•
SCO UNIX System V Release 3.2 Operating System version 4.2, SCO Open
Server/SCO Open Desktop Release 3.0, Open Server Release 5.0, and SCO MPX
Release 3.0
•
Banyan Vines