HP Remote Assistant Card - Manual (Page 30)

1 Introduction
12
NOTE SCO UNIX does not support a bootable HP NetServer Navigator Utility
Partition. Therefore you will have to create a separate bootable DOS partition
in order to run the HP Diagnostic Assistant, EISA Configuration Utility, or
the file transfer utility from a remote console.
HP Remote Assistant includes SNMP Agents for the following network operating
systems:
•
Novell NetWare v3.12, v4.1, and v4.1 SMP
•
Microsoft Windows NT Server 3.5 and 3.51
Remote Console Installation Requirements
For the remote console, you can use any ANSI X3.64 compatible terminal or terminal
emulator with a modem or RS-232 connection. For best results, use an ANSI color
terminal that supports 25-line mode and IBM PC character set, the configuration
supported by the HP Remote Assistant Communications Software (Terminal Plus).
Console requirements for Terminal Plus include:
•
A 386-based (or faster) computer with 12 MB of available disk space
•
A communications link to the server, either through a modem or a direct serial
connection
•
MS Windows 3.1, Windows for Workgroups, Windows 95, or Windows NT
Workstation 3.5 or 3.51
NOTE For NT Graphics Console Redirection, you must have Windows NT 3.51
with 16 MB of available disk space.