HP Remote Assistant Card - Manual (Page 158)

C Modem Commands
140
S-Register Unit Range Default Description
S11 1 mSec 80-255 80 Sets time duration of and spacing between
tones in tone-dialing.
S13 ASCII 0-127 37 Defines Remote Configuration Escape
Character.
S17 10 mSec 0-2.5 250 mSec Defines length of break time (space) to PC.
S24 50 mSec 0-255 20 Sets DSR/CTS/CD dropout time. Default
(20) equals one second.
S25 100 mSec 0-255 0 Sets DTR dropout time.
0 default equals 50 mSec.
S30 min 0-255 0 Inactivity timer used to disconnect modem.
S32 100mSec 0-255 20 Sets time that modem will wait for a
<RETURN> to be entered during escape
sequence execution.
S34 ASCII 0-60 10 Buffer size for number of characters in AT
command string after on-line escape
sequence, before buffer is cleared and
escape sequence aborted.
Result Code Summary
Digit
(Terse)
Words (Verbose) Effect
0 OK Command was executed without error; ready for next
command.
1 CONNECT Modem has detected carrier and gone on-line.
2 RING Modem has detected ring caused by incoming call.
3 NO CARRIER No carrier signal has been detected within allowed time.
4 ERROR Error in Command line (too many, or invalid characters).
5 CONNECT 1200 Modem has detected carrier at 1200 bps and gone on-line.
6 NO DIAL TONE No dial tone has been detected.
7 BUSY A busy signal has been detected.
8 NO ANSWER Remote system did not answer.
9 CONNECT 2400 Modem has detected carrier at 2400 bps and gone on-line.