HP Remote Assistant Card - Manual (Page 56)

2 Hardware Installation and Configuration
38
Page on System Configuration or POST Error. When enabled, HP Remote
Assistant sends a notification whenever it detects a system configuration error or a
POST error at system boot time.
Page on System Status Event. When enabled, HP Remote Assistant sends a
notification whenever the status of the server changes. Events such as a corrected ECC
single-bit error or a change to the server's configuration will cause notification. Status
events may be informational or they may describe problems with the server.
NOTE Regardless of which events you specify for notification, paging must be
enabled for paging of administrators to occur. For more information on
enabling paging for qualified administrators, see "Configuring Administrator
Names," later in this chapter.
Setting Sensor Thresholds
As part of its monitoring functions, HP Remote Assistant checks the server's internal
temperature, voltage levels, and bus utilization. Typically, the default values fit almost
any site's requirements and do not need to be modified.
If, however, you are operating at a site where environmental conditions are unusual, or
if you want to test HP Remote Assistant's sensor capabilities, you can change sensor
thresholds in the Sensor Thresholds window that appears when you choose Sensor
Thresholds from the Configuration Menu.
.